I’d check your pad switches and make sure they are not in the down position.
On Apr 27, 2017, at 8:10 PM, Chris Smart <csmart8@xxxxxxxxx> wrote:
I don't have that mixer, but perhaps channels have pad switches?
At 08:07 PM 4/27/2017, you wrote:
what sort of signal are we talking about here? A dynamic mic? A line level
source?
At 07:45 PM 4/27/2017, you wrote:
This may be a little off topic, but I think there are a few of you using
the Mackie 1640I mixer with Sonar and CT.
My issue; I have to take my gain setting to about the 3 o'clock position to
get enough signal in to Sonar. This is introducing a very noisy signal.
This is a pretty new issue as I have recorded plenty of things where the
gain setting was not even touching the 12 o'clock position. This is
happening on all 16 channels. Does anyone have a suggestion how to solve
this or perhaps something I can double check?
Thanks,
Grant
----------------------------------------
"There are two means of refuge from the miseries of life: music and cats." -
Albert Schweitzer
PLEASE READ THIS FOOTER AT LEAST ONCE!
To leave the list, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe
If this link doesn't work then send a message to:
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
unsubscribe
For other list commands such as vacation mode, click on the immediately
following link:
ddots-l-request@xxxxxxxxxxxxx?subject=faq or
send a message, to ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
faq
----------------------------------------
"There are two means of refuge from the miseries of life: music and cats." -
Albert Schweitzer
PLEASE READ THIS FOOTER AT LEAST ONCE!
To leave the list, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe
If this link doesn't work then send a message to:
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
unsubscribe
For other list commands such as vacation mode, click on the immediately
following link:
ddots-l-request@xxxxxxxxxxxxx?subject=faq or
send a message, to ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
faq