Eric,
The previous post referred to locomotives, but I did spend 3 months at the
Winnipeg Caboose Shop in the late 1980's not too long before the cabooses came
off.
the cabooses got scheduled maintenance like the locomotives. If I recall
correctly, they were also on a 90 day schedule. Modern cabooses had a fair
amount of equipment including 2 oil heating stoves, a diesel generator to
supply power for the lights and the electric cooking stove. As well, they had
a toilet and a water tank and sink. I do remember that a caboose was washed
(by hand) once a year. I don't know if cabooses were assigned to a specific
shop for maintenance or not.
At the time that I was there, we were expected to service at least 8 cabooses a
day so you can see that the time frame was fairly short. Sometimes a caboose
would stay longer due to a defective generator or other defect.
Hope this helps.
Paul
To: cpsig@xxxxxxxxxxxxxxx
From: mile179kingston@xxxxxxxx
Date: Mon, 18 Nov 2013 09:06:46 -0800
Subject: RE: RE: [cpsig] Engine Servicing and Van Assignment
Paul, can you describe the shopping process/timeframe for vans as well?
Though you were kind enough to give me some information on the duties during
each van shop visit, which I included in the post I linked to for Cyrus, I'm
interested in the frequency of same.
Eric Gagnon
Kingston, Ontario
http://newviarailbook.blogspot.ca
[Still can't get used to that 'retired' word after your name!]
---In cpsig@xxxxxxxxxxxxxxx, <pbsmith@...> wrote:
Jack,
CP units went in for scheduled maintenance every 90 days. These inspections
are called Datal inspections on CP. By setting a regular date for inspection,
the home shop would know when the unit is coming in and have required parts
(oil filters etc.) on hand. Also, the units were scheduled to allow a steady
flow of units through the shop. Of course, sometimes units break down, so then
the unit comes in for an unscheduled visit for repairs. Datal inspections vary
from a (small) 3 month inspection to a (bigger) 6 month inspection to a (large)
annual inspection. Every 2 years (24 months), included with the inspection,
would be an air brake change out. Portions of the air brake system were
swapped for cleaned and tested parts to ensure reliable operation of the brake
system. The air brake change out is mandated by Transport Canada for safety
reasons.
Each unit was assigned to a home shop which is responsible for maintaining the
unit. When a unit was getting close to its due date, the unit would be worked
back to the home shop in time for it's inspection.
Today things are a little different, but that is how it was done back then.
Paul Smith
Winnipeg
CP Rail, retired
From: jack.hofmockel@...
To: cpsig@xxxxxxxxxxxxxxx
Date: Sat, 16 Nov 2013 22:50:40 -0800
Subject: [cpsig] Engine Servicing and Van Assignment
Hi!
Two questions:
A.) What was (or was there a) rule of thumb as regards when diesel locomotives
were "shopped" for regular maintenance?
2.) How were vans assigned in the 70s?
Thanks!
Jack.
"ADDers can never say in 2 paragraphs what they could say in 10." :-)