Uwe:
That’s a very clever idea that might well work. I’ll have to find someone
with a large enough mill, but that might work.
Indeed, a simpler (to mill) lap joint might do the job if properly sealed.
Thanks,
Bill
On Sat, Aug 25, 2018 at 4:09 AM Uwe Klein <uwe@xxxxxxxxxxxxxxxxxxx> wrote:
Am 24.08.2018 um 16:12 schrieb William Claybaugh:
Unfortunately, the liner tubes come in 36” lengths which means there is
insufficient leftover material to do as you suggest; in addition, having
a seam at the seal does leave a theoretical leak point. Again, the odds
of that being an issue seem very low...but the consequence of failure is
very high.
Can you machine the liner faces with inner/ outer rabbet
and a bit of negative slope for a "click fit" style joint?
--------------------------------------
|________....
|
-------------------------------------------
( view with monospace font )
install with glue as lubricant.
Uwe