Jon, contact Carl at San Diego State Uni., they cloned those LR-101
injectors and should be able to help you.
I had a bunch of those entire engines but were stolen in 2010 by waldo.
Good luck,
K
On Thu, Aug 27, 2020 at 4:41 AM Jonathan Adams <jonadams2002@xxxxxxxxx>
wrote:
I just loaded up Solidworks to have a crack at CAD for that injector, and
I noticed that quite a bit of the injector blueprints are cut off,
especially on the hot-gas side of the side view. I'd love to be able to
make an accurate injector which I can have machined, and I somehow don't
think estimating the dimensions is a very good idea. Where did you get the
blueprints from, if I may?
On Wed, Aug 12, 2020 at 8:04 AM roxanna Mason <rocketmaster.ken@xxxxxxxxx>
wrote:
LR-101 illustration attached,
K
On Fri, Aug 7, 2020 at 11:45 AM 1bcjolly <1bcjolly@xxxxxxxxxxxxx> wrote:
This may help those working with the LR-101 engine. I have an LR-101
but no injector. Hope to get around to machining an injector plate one of
these days if my borrowed time doesn't run out first.
Barry
Sent from my Sprint Tablet.
