Thanks Graeme, it works!
Best regards,
Alberto
Hi,
the verification option stops it calibrating. It will calibrate
if you remove the "-e1".
I'll fix the bug in V1.7.1.
Graeme Gill.
On 05/09/2015 07:27 PM, Alberto Ferrante wrote:> Dear Graeme,
today I installed Argyll 1.7.0 and tried to perform the periodic
calibration of my monitor. Though, I soon discovered a problem with
dispcal: setting -qh (or m), the tool states that will do the correct
number of rounds (4 for -qh), but then it stops after the first one. It
does not even perform the check step, even though I have set it in the
command. Following the command line that I used:
dispcal -t6500 -gs -b100 -qh -Yp -v -e1 -yb eizoCX240
My colorimeter is an x-rite i1 Display Pro
I checked the documentation, but I could not find anything useful w.r.t.
this problem
Best regards,
Alberto
