[argyllcms] Re: Windows 7 color management problem
- From: Dimitrije Zivkovic <migraf.keramika@xxxxxxxxx>
- To: argyllcms@xxxxxxxxxxxxx
- Date: Wed, 21 Nov 2012 13:17:31 +0100
I use PS driver only.
So strange is also if I use option "BLACK GRAY BY K" or "BLACK GRAY BY CMY+K"
got the same results.
I do it all the time, and now this is new situation.
With Mac computers I never had problems.
But with Windows 7 always.
Never ending problems.
Regards
Dimitrije Zivkovic
On Nov 21, 2012, at 1:12 PM, Nikolay Pokhilchenko <nikolay_po@xxxxxxx> wrote:
> As far as I know, You could use black generation and perform CMYK profiling
> only when You able to print true CMYK. There may be the case when You
> printing in PostScript (PS) mode on PostScript-enabled printer driver or when
> You using special RIP software. If You printing with ACPU or ftom CS6 in GDI
> mode (non PS), Your printer acts like an RGB device. So, You can not control
> black generation and even can not to build working profile in CMYK mode.
> Just profile in RGB mode and it will be OK.
>
>
> Wed 21 Nov 2012 11:57:44 от Dimitrije Zivkovic <migraf.keramika@xxxxxxxxx>:
> Hi everybody
>
> I try to make profile for the Ricoh printer and printed patches from Adobe
> color printer utility.
> When I finish profile, and try to print, color profile was not ok. Photoshop
> CS6 print something differently than accurate color conversion.
>
> Than I try to print patches from Photoshop 7, old one, and again profile
> looks ok, but after printing something not ok. Driver always want to print
> gray and black only with black color, even I change it with profile (-kp 0 0
> .97 .87 .75)
>
> The profile that I made printing from Photoshop 7 doesn't work when I print
> from Adobe color printer utility.
>
> I check in Color Management in Windows 7 and there is nothing, I mean nothing
> is selected for printer.
>
> Does anyone has same problem?
>
>
> Dimitrije Zivkovic
>
>
Other related posts:
