Dear list.
I feel like a bit of an idiot but sure this should be obvious! I have a number
of external video monitors, so they are in no way connected to the computer, of
which I would like to lineup using PLUGE coming from our signal generator. What
would be the best way to do this?
I have come to Argyll from initially finding the DisplayCal front end, which I
couldn't find a way to just display the reading being updated live, preferably
with a flat reference level set as desired (D65 in my case.)
So the closest I have found is to use your "spotread -T" command to give me
reading as I run the command (or combine with watch to get it automatically
updated.) At least this gives me a temperature reading but I would still
consider it less than ideal.
Is there a guide anywhere on the recommended way of doing this or any pointers
you can give me?
Kind regards, Dale.