This message was posted by Rod or Sharon on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/2/1199.html#000001 Yes, It would be a lenghty explanation as you did not indicated Ver 7 vs Ver 9.....It is called "Split Element" in both but is an icon in the toolbar in & and found under the "Object" dropdown menu in Ver9. Check out your "Help" section for "Split Element" in DS, as splitting Singleline vs Column 1 vs fills vs walk stitches has slight variations. Just know that you cannot split between "Curved" wireframe points, only "Straightline" points, meaning that you may need, in some cases, to add straight line wireframe points to split in a required area. Rod Springer Amaya Tech & Trainer =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================