This message was posted by Rod or Sharon on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/1136.html#000005 John is right, but just for information purposes...... Big Reds.....the needleplate should always be reinstalled with the needlecase moved to the #9 needle position. XT series.....The needleplate should always be reinstalled with the needlecase moved to the #1 position. This has to do with how the needlecase was calibrated or is being calibrated on the individual machines so the needle will disect the exact centerline of the bobbin shaft spindle. The Big Reds use an optical laser sensor to control color change position. The needlecase is calibrated at the #9 position and needleplate centered, but all the other needles will vary on the exact centerline bercause of tooling tolerances. The XT series does not use this laser system. It uses an encoder on the color change motor. This allows "each individual" needle to be calibrated to the exact centerline of the bobbin shaft spindle. The computer will remember these positions. Therefore...if the needle is on spindle center....it is important, because of tooling tolerances in the needleplate that allows it to move slighly to the left and right, the needleplate needs to be aligned so the needle is dead center of the hole before it is tightened down. Rod Springer Amaya Tech & Trainer =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================