This message was posted by Debbie Rinehart on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/1/295.html I loaded a name, first and last, on my XT tonight and it looks centered on the screen, but when I trace, it is definately well below the center marks on the inside of my hoop. I tried to reload other names that stitched alright earlier but everything was down at the bottom of the hoop. I had to use the machine keypad to manually move the name up about an inch before it appeared to be ALMOST dead center. However, if you got it centered perfectly in the hoop, on the screen, the name looked looked like it was over the hoop limits and I get a message saying it is. This happened after going to my slim line setting and stitching out a couple bags. When I noticed it after I went back and chose my round hoop 5.85. I tried changing hoop sizes, resetting etc, all to no avail. Is there a way to get the design and hoop in sink. Debbie in Indiana =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================