This message was posted by Gary McB on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/1039.html I just replaced the presser foot on one of my XT machines. I went through the color change calibration and saved it. My problem is when I click on the home button or start the machine, it goes too far to the left, causing the #16 needle to drop. If I can hold the needle up while it seeks home, everything is fine until I start the machine again. Can anyone help?? =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================