This message was posted by Rod or Sharon on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/2/1363.html#000001 What version of software? XT machine? Are yo u using auto or standard actifeed? If you are using auto actifeed, try using the auto lower limit settings under Settings, thread feed and increase it up a cople of points or more. This will increase the amount of thread fed to the design. Use of the "Column feed" on this same page will help also as well as use of the run/fill tool to feed more thread to the stitch to keep it from pulling the bobbin to the top.... Rod Springer Amaya Tech & Trainer =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================