This message was posted by Steve I on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/1345.html#000005 Chrissy, It's not so much the material thickness setting as the lower limit being too low. If you are running in "auto" mode the material thickness will take care of itself but the lower limit will stay where it is set. If you havent finished yet try increasing the lower limit and you should be able to speed things up. Steve I. Trinity Embroidery =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================