This message was posted by Hugo Torbidoni on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/2/1265/2.html#000018 Megan, I know I spoke to you earlier but thought I would post this in case anyone else has issues with this application. All previous posts are good suggestions here,,, Have you checked your Auto feed lower limit setting? If it's at default the machine will drop down to the lowest "Material Thickness" it sees as it starts laying down the napp on the towel. By the time it starts to stitch the satin stiches it may get tighter than it needs to be and eventually allow the nap to poke through in places. And always check your bobbin case make sure its clean under the tension spring. Hugo =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================