This message was posted by Mary on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/2/599.html#000009 I did forget to lower the presser foot and realized it before I sent out the first forum post. This happened to be on the needle that I had to replace. The design only used two colors and after I changed out the needle it worked fine. Now I'm doing the 4 Mil Stich Maint and I have about another hour to go on that one! BTW I was doing hats the last couple of days and I'm going to assume the needles are bad and just change them out and try them again. Roland- I will try those suggestions as soon as I can....thank you :) =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================