This message was posted by The Embroidery Authority on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/1/496.html#000012 The teflon tape was originally installed on the ICTCS hoop at the factory. This hoop was the predecessor to the slimline. This tape works like a bib does. It's there just in case you were to drip pudding on your shirt. Meaning that the tape pads the underside of the rear of the slimline if it happens to rub against the bobbin/sewing arm. When I adjust the slimline, I do so so that the rear underside has about 3mm clearance from the top of the bobbin/sewing arm. Hence, the teflon tape is not necessary. Here's something else to consider, Every once in a while I have to check these settings to verify they are correct because they can change over time in the battle field with use. Especially if your employees have strong arms. Ed =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================