This message was posted by The Embroidery Authority on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/1/481.html#000001 Hello Linda, .DST files, by nature, cannot retain trim commands. During the conversion from .OFM to .DST, trim commands are converted to something like 6 jumpstitch commands. Most commercial machines have the ability to covert over a specific number of jump stitches to trim commands. On the Amaya it's set at 3 jump stitches by default. My suggestion to you is to save your files as .EXP files and send them to your PR600 in this format. .EXP files do retain trim commands. If your PR600 cannot recognize the .EXP format, then you will probably have to open up your design in the PE Designs software and either put in your trims again or possibly your Brother software will have the ability to insert trims for you, by default, based on the software settings. Just curious, Do you not own the PE Designs software? I understand it is sold with the machine. Maybe not in every case? Thanks and hope this helps, Ed Orantes Melco Tech & Trainer 504-258-6260 =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================