This message was posted by Greenwing on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/2/1299.html#000005 Lisa What are you trying to do?? The needle depth on any machine is a set depth durring the timing process. their ar no machines that allow on the fly depth change. It must be set exactly to allow the hook to pick up the thread and loop the bobbin. if you think your stitches are being pulled too tight then increase the lower therad feed # or increase the material thickness # and see if that helps. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================