This message was posted by Posylane on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/1137.html I am doing practice sew outs on our new XTS and I have seen a few cases where the needle case will either stop, seemingly because of some resistance, or have a little difficultly passing over some needle positions. I went though the lubrication points before testing but in some cases the pictures were hard to figgure out. In any case the machine didn't seem to need it. Lots of greese in the points to be greased. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================