Hello,
Juli in Kona has just posted in the Machines & Hardware forum of AmayaUsers
Discussion Boards under the title of trimming troubles.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?6167-trimming-troubles
Here is the message that has just been posted:
***************
Many times when trimming, the thread ends up about 6 inches shorter than it
should be. That means it is out of the needle and out of the 2 holes above
that. WHY does this happen, AND how can I fix it? Extremely time consuming
and very frustrating.
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================