Hello, SkyLinePrints has just posted in the Machines & Hardware forum of AmayaUsers Discussion Boards under the title of False bobbin break on single needle. This thread is located at http://www.amayausers.com/discussion/showthread.php?5752-False-bobbin-break-on-single-needle Here is the message that has just been posted: *************** Hi everyone, I have searched the forums but did not find a topic for my problem. I have an XTS that is giving false bobbin breaks on needle 1. It runs fine on all the other needles. Thanks I have done: 1) moved thread to another needle 2) cleaned red rollers 3) cleaned bobbin casing 4) checked for obstructions etc... some other small stuff but I still have the same issue on needle 1. Any tips or suggestions? Thanks in advance. *************** =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================