Hello,
Judy has just posted in the Machines & Hardware forum of AmayaUsers Discussion
Boards under the title of Melco Amya big red not cutting.
This thread is located at
http://www.amayausers.com/discussion/showthread.php/6962-Melco-Amya-big-red-not-cutting
Here is the message that has just been posted:
***************
If you have an old Big Red that had only two hours on it, I would first ask if
it had a motherboard replacement. My 100 million stitch XT is now "brand new"
courtesy of a new motherboard.
A lot of things can cause improper cutting. A dull knife is the first that
springs to mind. Push rods needing lubrication or being bent or out of time is
another. A cutter that needles cleaning and oiling. Improper hooping tension.
Wrong thread type. Bad timing. And other I am sure I am not listing.
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================