Hello,
AndyXRT has just posted in the Machines & Hardware forum of AmayaUsers
Discussion Boards under the title of X Motor Home Timeout.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?6285-X-Motor-Home-Timeout
Here is the message that has just been posted:
***************
Hi,
I have an AMAYA XT (Early model). Our machinist was using the machine recently
and the hoop ran all the way to the right and came up with the message on Amaya
OS "X Motor Home Timeout". I tried some of the suggestions in this forum of
switching off, moving the frame and re-initialising. Also tried cleaning the X
and Y sensors. No Joy. Even did a force-download from the software to the
machine.
If I load up the maintenance page, both X and Y home sensors seem to remain in
the same state (both blocked if I recall correctly). Moving the hoop arm to any
extreme doesnt seem to change this state (on either axis). Neither does a
manual interruption of the Y-sensor beam change it's state. I have ordered a
replacement Y sensor / PCB as it appears to be the junction for the X and Y
sensor wiring.
Has anyone else had similar issues or could anyone shed any further light on
diagnostics?
many thanks,
Andy
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
