This message was posted by Rod or Sharon on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/3/630.html#000001 The "get table" "set table" functions are processes used in regards to the calibration of the needlecase in relation to each individual needles exact positioning with the center of the bobbin shaft spindle. Calibration of the needlecase should only be taken on by those that have proper training and/or those that have a full understanding of the processes involved with doing this. These functions are use on the XT series machine and will not work on Big Reds. Rod Springer Amaya Tech & Trainer =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================