This message was posted by HERB on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/8/78.html#000002 if you are breaking screws on your machine you are putting too much torque on them. Put the screws in finger tight, then turn them 1/8 turn maximum with the allen wrench. May not seem tight to you but if you look at the thread diameter this is all it needs. Been doing it this way for 5+ years, no broken bolts, no stripped threads. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================