[amayausers.com] Re: 3D Puff
- From: webmaster@xxxxxxxxxxxxxx
- To: amayausers@xxxxxxxxxxxxx
- Date: Wed, 21 May 2008 08:10:26 UT
This message was posted by Juli in Kona on AmayaUsers.com. PLEASE DO NOT REPLY
VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here:
http://www.amayausers.com/boards/ultimatebb.php?/topic/2/564.html#000001
The thing that you have to do is to flatten the ends of each letter. Take the
letter F. You have 3 blunt ends. You have to digitize zig zag stitches on
each end to flatten them down. Then use only the edge walk underlay. Using
the 2mm puff foam will give you a very nice loft and make sure that it is the
same color as your thread (or I'd go darker if yu can't match it well). Set
the presser foot up pretty high. If you do "center Down" you can play with it
until it touches but doesn't flatten the foam. The actifeed should be set
really high - 20 is probably not too high. And practice on scrap before you
commit your hat!
Good luck,
Juli in Kona
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
Other related posts:
