I think you'll be able to find the update button by doing control +tab once your cursor is in the right tree view. -----Original Message----- From: access-uk@xxxxxxxxxxxxx [mailto:access-uk@xxxxxxxxxxxxx] On Behalf Of martin wilsher Sent: 22 September 2006 11:12 To: access-uk@xxxxxxxxxxxxx Cc: jaws-uk@xxxxxxxxxxxxx Subject: [access-uk] Jaws and nod 32 control centre. Hi list: Please could someone help? I have installed nod 32 on my laptop to test it prior to instillation on my desktop. I disabled graphical interfaces in custom setup, as well as the splash screen at programme start-up. On reading the help files, I read that to update the nod 32 components, I have to select update from the control centre and then press the setup button to the right of the list. I can't find this button. There is a selection that can be made from the list called nod32 system setup, is that what I need to click on? I understand I will only get some protection as I'm using the 30 day trial version of the software and will need to purchase the licences to activate the product. I am concerned however, as I can't access the registration screen, which the help files tell me should pop up when I select update and then the setup button, wherever that is. I also run zone alarm on that laptop, and it seems their registration process is easier than the one for nod32. Any help you could give will be appreciated. P.s. Tried looking on the essit site for support, and I can't find an email address to write to. I dumped kerio firewall for the same reasons. I didn't like their site etc. Thanks Hope to hear from you soon. From Martin. Please email me at: m.wilsher@xxxxxxxxxxxxxxxx Thanks Please visit my website: www.martin-wilsher.co.uk ** To leave the list, click on the immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** access-uk-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq ** To leave the list, click on the immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** access-uk-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq