Perhaps a silly question, but assuming you have the dot ISO file, are you correctly burning it as a .ISO, which is not the same as simply burning the installation file to a CD? George. -----Original Message----- From: access-uk@xxxxxxxxxxxxx [mailto:access-uk@xxxxxxxxxxxxx] On Behalf Of Chris Hallsworth Sent: 15 April 2009 19:28 To: access-uk@xxxxxxxxxxxxx Subject: [access-uk] Burning Vinux to a CD-RW Hello all, I'm trying to burn Vinux onto a CD-RW. I've tried UltraIso, PowerIso and IMGburn. It seems to burn fine, but with two programs (UltraIso and IMGburn)I get problems verifying the disk. IMGburn even tells me some diagnostic but cryptic messages, and also told me that one of the sectors is smaller than the sectors in the image. Does this therefore mean that the disk is at fault, and if so should I try another disk, as I've got ten in total, all CD-RW's? All help would be greatly appreciated as this is driving me mad! P.S. Oh yes, the problem is it burns ok, but when I try to start it with the computer it doesn't seem to boot properly and I no doubt get an error message, to which I've got no eyeballs to help me read it. Thanks in advance, as this is driving me mad! -- Chris Hallsworth e-mail: christopherh40@xxxxxxxxxxxxxx MSN: ch9675@xxxxxxxxxxx Skype: chrishallsworth7266 Join deaf blind support by sending a blank message to deaf-blind-support+subscribe@xxxxxxxxxxxxxxxx ** To leave the list, click on the immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** access-uk-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq ** To leave the list, click on the immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** access-uk-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq