Phil, R3243 is located right next to the HOT heatsink very difficult to see and just as difficult to get out, Larry E Larry Eastman American TV & Electronics Crystal River, Fl. 34428 Phil Bader wrote: > Senior moment...I've replaced these...Trying to physically locate R3243 > and R3244 on sweep module. > Location, please? ;-) > Phil Bader > > Phil Bader wrote: > >>This 46" Zenith PTV unit has a 9-1674 main, but has a bad converg. >>module 9-1690. The house power went on and off several times rapidly and >>this is the result.On this converg panel( 9-1690)two resistors are >>toasted feeding the two STK0392-110 chips (IC4008,4009) >>The resistors are R1460 and R1463. I think they are 1 ohm, need to >>verify. >>I will also change the STK's. >>Phil Bader >>-- >>Philip Bader >>Jan Phyl TV Inc. (estab. 1976) >>3420 Recker Hwy. Winter Haven, Fl. 33880 >>Fax (863) 299-8821 >>email: philbad@xxxxxxxxxx >> >>------------------------------------------ >>Submit A Repair Tip For Everyone Here: >>http://www.tech-assist.org/secure/tip/main.html >>------------------------------------------ >>To REMOVE your email address, click here: >> http://www.tech-assist.org/unsubb.html >>To CHANGE your email address, click here: >> http://www.techassist.net/forms/change.html >> > -- Larry Eastman American TV & Electronics Crystal River, Fl. http://www.tvjunkyard.com ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html