Found the problem. I was looking for burned resistors and there was none but there was open 1ohm resistors, so I guess I need new convergence IC's STK391-020. Thanks for response. Goes to show can't do just a visual. Al Marquardt ampm@xxxxxxx Al Marquardt Electronic Repair 206 W Main Girardville Pa. 17935 ----- Original Message ----- From: "Avery Boyd" <adBoyd@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, August 25, 2004 5:05 PM Subject: [TechAssist] Re: Zenith PV4663RK Top and bottom bowed,no convergence control > What about the IC's. Also the 110k resister on the 1302 board. QX3201 I have > found bad also. Avery > Avery Boyd > 4666B S. Mingo > Tulsa OK 74146 > Phone 918-665-2400 > ----- Original Message ----- > From: "al m" <ampm@xxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Wednesday, August 25, 2004 3:59 PM > Subject: [TechAssist] Zenith PV4663RK Top and bottom bowed,no convergence > control > > > This set has all the voltages to the boards but the top and bottom are bowed > and the convergence is way off and cannot adjust. I checked the two > resistors that usually cause this and they are ok. At this moment I am still > hunting so if anyone has seen this before I'll check later for the fix. > Thanks. > Al Marquardt > ampm@xxxxxxx > Al Marquardt Electronic Repair > 206 W Main > Girardville Pa. 17935 > > > > -------------------------------------------------------------------------- -- > - > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/