What about the IC's. Also the 110k resister on the 1302 board. QX3201 I have found bad also. Avery Avery Boyd 4666B S. Mingo Tulsa OK 74146 Phone 918-665-2400 ----- Original Message ----- From: "al m" <ampm@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, August 25, 2004 3:59 PM Subject: [TechAssist] Zenith PV4663RK Top and bottom bowed,no convergence control This set has all the voltages to the boards but the top and bottom are bowed and the convergence is way off and cannot adjust. I checked the two resistors that usually cause this and they are ok. At this moment I am still hunting so if anyone has seen this before I'll check later for the fix. Thanks. Al Marquardt ampm@xxxxxxx Al Marquardt Electronic Repair 206 W Main Girardville Pa. 17935 ---------------------------------------------------------------------------- - Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/