[TechAssist] Re: Sony VCR SLV-360, cassette goes in and come right back out
- From: "J Silverman" <greentron@xxxxxxxxxxxxxxxx>
- To: <techassist@xxxxxxxxxxxxx>
- Date: Wed, 4 Dec 2002 13:59:32 -0500
Have you checked the end sensor system and cranked through the loading
manually to check for binding? Also look for a lever or switch that might be
used to detect the presence of a cassette.
Jerry Silverman
Greentron Inc
4 Newland Ave
Greenville SC 29609
864 232 3889
Fax 271 2080
mailto:greentron@xxxxxxx
----- Original Message -----
From: "Gary McCartney" <gary@xxxxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Tuesday, December 03, 2002 3:01 PM
Subject: [TechAssist] Sony VCR SLV-360, cassette goes in and come right back
out
>
> This Sony VCR model SLV360 came into the shop with a cassette stuck
> inside it. I had to remove the carriage in order to free the cassette. I
> noticed that the FL-loading gear # 3-958-156-03 had some chewed teeth so
> I ordered a new one. Now I have it all installed back together and the
> cassette will go into the machine, all the way down to it's resting
> position but instead of the mechanism pulling the tape out of the
> cassette and loading it, the cassette just reverses and ejects on me. I
> have cleaned the mode switch. Also checked the alignment of the loading
> gears, which look ok to me although I don't have a manual to do this by.
> for a photo of my alignment, clink on link:
>
>
> http://www.number63.ca/gears.jpg
>
>
> I cleaned the grease off the slide plate "rack" gear teeth and they look
> as I believe they should. The first tooth is only half as high as the
> rest but it looks like it was manufacturerd that way, not as if it looks
> broken.
>
>
> To see picture of teeth on slide plate, click on link:
>
> http://www.number63.ca/deck.jpg
>
>
> I removed the loading motor so I could spin the gears manually and after
> the cassette loading is complete, the gears lock up and won't allow the
> tape loading procedure to start. It appears as though it's the fault of
> the FL loading gear which I replaced because as the large black gear
> rotates, the FL gear's flanges hit the teeth on the black gear and
> prevent any further rotation. Still, I'm sure the FL gear is in proper
> position.
>
>
> I'm stuck on this one, any help appreciated.
> --
>
>
>
>
> Gary McCartney
>
> McCartney Electronics
> 7134 Fife Rd, RR 7
> Guelph Ontario Canada N1H 6J4
> Fax: (519)821-1530
> email: gary (at) number63.ca
>
> ------------------------------------------
> To REMOVE your email address, click here:
> http://www.tech-assist.org/unsubb.html
> To CHANGE your email address, click here:
> http://www.techassist.net/forms/change.html
> ------------------------------------------
> ***NEW*** Tips Added Instantly!!!***
> Submit Repair Tips here:
> http://www.tech-assist.org/secure/tip/
>
------------------------------------------
To REMOVE your email address, click here:
http://www.tech-assist.org/unsubb.html
To CHANGE your email address, click here:
http://www.techassist.net/forms/change.html
------------------------------------------
***NEW*** Tips Added Instantly!!!***
Submit Repair Tips here:
http://www.tech-assist.org/secure/tip/
Other related posts:
