Hi Chuck this is the voltage you should have at the tuner pins agc=2.5--As=0--Scl=4.5--Sda=4.4--Mb=5--Pb=5--Tb=33--If =0 this is for low band 2 to 6 .Check the voltage see what you have Eric E M Electronics Deer Lake Nfld Eric Manuel Hoyt's TV wrote: > > I don't know about that model but most need 33v going to the tuner somewhere > or a variable tuning voltage. Do you have snow? > You may need 12v at two places. One to power the mixer and one to either vhf > lo, vhf hi, uhf, cable. > > Russ Hoyt > Hoyt's TV > Exeter, NH > > ----- Original Message ----- > From: "hivolts" <hivolts@xxxxxxxxxxxxxxxx> > To: "techassist" <techassist@xxxxxxxxxxxxx> > Sent: Sunday, June 20, 2004 6:16 AM > Subject: [TechAssist] Sanyo DS25390 looks like tuner problem > > > Ok let try this one more time lol.when this set came in I had sound but no > pic just what looks like herring boning.I have change the tuner and the ant > block because some one had tried to do a make shift repair.but I still have > some what of the same problem.but I did notice when I went to autoprogram > the set is now says no signal on either air or cable.I do not have the > manual for this one.but I do have 12 volts and 5 volts at the tuner assy I > think it may be a chip but not sure. > > thanks > > Chuck Staples > > Staples TV > > Phippsburg Maine 04562 > > > > hivotls@xxxxxxxxxxxxxxxx > > > > > > -------------------------------------------------------------------------- > --- > > Lost Password: > > http://www.tech-assist.org and select "Login Problems?". > > Email Archives: > > //www.freelists.org/archives/techassist/ > > > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/