You didn't mention anything about the SERVICE adjustments or if they responded? You can't fix those problems with the" customer convergence"!!!!!!!!! Projo modules are not even close to being 'plug 'n play", so don't expect that replacing that stuff is going to give you a finished result. Sounds like you've got a bit of work ahead of you... There are very specific line landing parameters which are in the very badly written adjustment manual. You may even want to get the screen overlay jig since you are starting with a fresh DCU. I hope you gave the custoner a "healthy" estimate! Jim McVey McVey Alltronix 327 Broadway Newburgh N.Y. 12550 Factory authorized service for over 20 major brands. 845 561 8383 Alvin Rose wrote: >Hi Guys >we have a Samsung SP431JX chassis projection tv with poor >convergence..The convergence will setup ok in the center but is >off badly on both sides..also is bowed a lot in the bottom and >top corners..also remote will not go in to the setup mode with >mode 183..I have replaced the green convergence amplifier >IC STK391-020 and had the convergence module overhauled >by Samsung...Any suggestions or help would be appreciated >Alvin Rose >Radio & TV Centre >Marystown, NL. > > > >----------------------------------------------------------------------------- >Lost Password: >http://www.tech-assist.org and select "Login Problems?". >Email Archives: >//www.freelists.org/archives/techassist/ > > > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/