Have you replaced the parts in the Regulator circuit. 3 Caps and the IC. -Ed- Tel-Tek Electronics Midland, Ontario Canada. teltek2@xxxxxxxxxxxx ----- Original Message ----- From: "Larry E." <videotech@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, September 20, 2002 1:12 PM Subject: [TechAssist] RCA CTC169BG2 model# F35100ST Dead > > Hi guys, working on a CTC169 BG2 chassis, set develops HV for 1 second > and immediately collapses,I have normal Raw and Regulated B+, 15v > standby is @ 12.5 volts, 5 volt standby is 4.8 volts. Replaced cr4118 > and C4145 made no difference. Pulled the jumper wire jw324 to disconnect > the 15 volt B&C loads and the 15v line only came up to 13.6, is this > normal B+ in standby or does it indicate a load on the 15 volt "A" > source ? HV doesn`t stay up long enough to indicate if the 26 volt > scan derived source is trying to develop or not, any help appreciated. > > -- > Larry Eastman > American TV & Electronics > Crystal River, Fl. > http://www.tvjunkyard.com > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/