I have yokes, but not for this tube. Inspected yoke for corrison, look good. I measured 8 ohms across vertical coil. David -----Original Message----- From: techassist-bounce@xxxxxxxxxxxxx [mailto:techassist-bounce@xxxxxxxxxxxxx]On Behalf Of peggs Sent: Thursday, December 12, 2002 2:44 PM To: techassist@xxxxxxxxxxxxx; techassist@xxxxxxxxxxxxx Subject: [TechAssist] Re: Phillips 25P1-02 chassis - Model# PK4485 (CH03) This must be a different chassis than the Open resistor I spoke of. Can you sub a Yoke ??? Peggs At 11:12 AM 12/12/02 -0500, David Lessard wrote: > >Gentlemen, > >Vertical size is only 6" (in the center), replaced (5) caps in vertical >circuit and LA7838, problem still there. Vertical adjust has minimal effect >on size. Something in the sync seperation circuit? Schematic would come in >real handy. > >Thanks. > >David Lessard >Alexandria Electronics >50 Harrison Street >Alexandria, Ontario >(613)525-4502 >mrfixit@xxxxxxxxxxx >------------------------------------------ >Submit A Repair Tip For Everyone Here: >http://www.tech-assist.org/secure/tip/main.html >------------------------------------------ >To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html >To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > > Peggs' Electronics 1519 West 2nd Street Owensboro,KY 42301 270-926-4968 fax 270-686-7399 ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html