have no manual either Don. i usually disconnect the tuner IF pin and inject it on the trace. after the saw filter there should be two pins that go to the IC, should be from 2 to 4 volts on them. inject the signal on them. al marquardt ampm@xxxxxxx ----- Original Message ----- From: "Don Hartigan" <hartstv@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, May 17, 2002 8:28 AM Subject: [TechAssist] Re: Orion-TVCR mod#tvcr1321,blue screen > > Al,have no print,where is the injection point for SAW? also I lose the IF > sig in a maze of traces on this board.Tryed getting a schematic from Orion > but they say NLA.tks for your reply....Don....... > HARTS-TVCR''ASC'' > 9-Robert St.,Oromocto,NewBrunswick,CAN > Tel#506-357-9785Fax#506-357-6010 > ----- Original Message ----- > From: "al m" <ampm@xxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Friday, May 17, 2002 8:56 AM > Subject: [TechAssist] Re: Orion-TVCR mod#tvcr1321,blue screen > > > > > > Don did you try putting in an IF signal after the tuner, and after the Saw > > filter. > > al marquardt > > ampm@xxxxxxx > > > > > > ----- Original Message ----- > > From: "Don Hartigan" <hartstv@xxxxxxxxxxx> > > To: <techassist@xxxxxxxxxxxxx> > > Sent: Friday, May 17, 2002 6:31 AM > > Subject: [TechAssist] Orion-TVCR mod#tvcr1321,blue screen > > > > > > > This unit has blue screen when rf connected to cable i/p.VCR has good > > picture/sound on playback.A/V inputs ok.I subbed out the tuner,no > > help,&checked voltages;BT=30vdc,BP=5vdc,BM=9vdc,AGC line is sitting at > > 7.5vdc.Unit will sometimes show a very snowy,no sound picture,which cannot > > be changed by trying to channel up/down,#'s on screen will change.Unit > will > > auto-program.This uses a LA7583=IC6001 in the tuner cct,as per data sheet > > it's the VIF/SIF control ic,voltages to it are ok.Have checked my parts > > sources & they don't list it.Does anyone have one or know where I can get > > it.It ''MAY'' be my problem.All i/p's welcome on this little > > 13''..TIA..Don....... > > > HARTS-TVCR''ASC'' > > > 9-Robert St.,Oromocto,NewBrunswick,CAN > > > Tel#506-357-9785Fax#506-357-6010 > > > > > > ------------------------------------------ > > > To REMOVE your email address, click here: > > > http://www.tech-assist.org/unsubb.html > > > ------------------------------------------ > > > ***NEW*** Tips Added Instantly!!!*** > > > Submit Repair Tips here: > > > http://www.tech-assist.org/secure/tip/ > > > > > > > > > > > > ------------------------------------------ > > To REMOVE your email address, click here: > > http://www.tech-assist.org/unsubb.html > > ------------------------------------------ > > ***NEW*** Tips Added Instantly!!!*** > > Submit Repair Tips here: > > http://www.tech-assist.org/secure/tip/ > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/