Your EPROM is probably corrupted. Look a the values in service mode.......see if they are all reset at 127 ! ========================== Jeff Stielau Shoreline Electronics Repair 344 East Main Street Clinton,CT 06413 860-399-1861 860-664-3535 (fax) jstielau@xxxxxxxx ======================== "If you push something hard enough it will fall over." Fudd's First Law of Opposition - Sir Sidney Fudd ----- Original Message ----- From: "Robinson Electronics" <RobinsonElectronics@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Sunday, November 14, 2004 4:53 AM Subject: [TechAssist] Mitsubishi VS-4543 Chassis VZ3: Convergence problem. > Can any of you Techs. Help me with this problem? > This set had a convergence problem, red and blue was way off. I replaced > all "3" STK391-020. > > Now my problem is a yellow / blue tint, bowed down from the top in the > upper left hand side of the picture, more noticeable at the top, but some > at the left bottom also. > > When I try to align the convergence cross, the red and blue cross is not > straight, both red and green are bowed, or bent at the top. > > Now I'm wondering if the generic STK's I installed are bad, but the > convergence is good all over but the left side, mostly at top corner. > > Has anyone seen this before on this chassis / model or can help with ideas > on what to try next? Thanks. > > David. > > Robinson Electronics > 1075 Sweeten Creek Road > Asheville, NC 28803 > Ph./Fax. 828 274-3787 > Toll Free. 1-888 ROBELECT > www.robinsonelectronics.com > www.robelect.com > Mailto: RobinsonElectronics@xxxxxxxxxxx > > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/