Normally a bad vertical output kills the power, if it has sound.....check the regulator resistors/connections after verifying your power supply. Of course your customer may have routed his sound to a separate amp, and if so --check that vertical Damon ----- Original Message ----- From: "Shoreline Electronics" <jstielau@xxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, October 02, 2001 8:51 PM Subject: [TechAssist] Mitsubishi CM Kit Question > > Question : > > With a CM kit installed on a V10/V10B chassis , if the vertical circuit > fails , will the audio still stay on OR will it still shut the whole set > down? > > Reason I ask is we just did a VS6015R today where the set would do exactly > that...lose video & OSD ( Not sure if HV or filaments went out...we just > tore into it). > > We pulled all 3 boards & resoldered all the usual stuff that gets charred & > replaced all the usual caps we always do......set ran for a couple hours > then quit. This set is at customers house so we'll have to go back & do > battle again. > > I'll check for HV & filaments when this happens. > > > > Jeff Stielau > Shoreline Electronics Repair > 125 Beechtree Lane > Westbrook,CT 06498 > 860-399-1861 Voice > 860-664-3535 Fax > jstielau@xxxxxxxx > > ----- Original Message ----- > From: "Shoreline Electronics" <jstielau@xxxxxxxx> > To: "TV Repair Group" <tv-repair@xxxxxxxxxxxxxxx> > Sent: Tuesday, October 02, 2001 9:50 PM > Subject: Mitsubishi CM Kit Question > > > > Question : > > > > With a CM kit installed on a V10/V10B chassis , if the vertical circuit > > fails , will the audio still stay on OR will it still shut the whole set > > down? > > > > Reason I ask is we just did a VS6015R today where the set would do exactly > > that...lose video & OSD ( Not sure if HV or filaments went out...we just > > tore into it). > > > > We pulled all 3 boards & resoldered all the usual stuff that gets charred > & > > replaced all the usual caps we always do......set ran for a couple hours > > then quit. This set is at customers house so we'll have to go back & do > > battle again. > > > > I'll check for HV & filaments when this happens. > > > > > > Jeff Stielau > > Shoreline Electronics Repair > > 125 Beechtree Lane > > Westbrook,CT 06498 > > 860-399-1861 Voice > > 860-664-3535 Fax > > jstielau@xxxxxxxx > > > > > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. > Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.