Check resistors in vertical circuit I had same problem found open resistor 1/4 or 1/2 watt don't remember value or location no notes may have been different model/chassis Robert tvservice@xxxxxxxxxxxxxxxxxxx H & H Electronics Inc ----- Original Message ----- From: "roger birmingham" <rogerselectronics@xxxxxxxxx> To: <Techassist@xxxxxxxxxxxxx> Sent: Monday, October 21, 2002 1:13 PM Subject: [TechAssist] Magnavox(Picture slow pulling out vertically) > > Magnavox(MODEL: RG5946---possibly 26C8 chassis) > > Problem: > > When first turn on set the picture is squeezed down to about 5 inches. > > Also no video(blank screen). > > After about 30 seconds the picture will come in and will start spreading out vertically. > > Have replaced vertical IC-580 > > Put in TDA3654Q( wondering if this is the right chip) > > When set first came in no vertical deflection. > > > > Any help appreciated. > > > > Rogers Electronics > > 1-205-698-8047 > > > > --------------------------------- > Do you Yahoo!? > Y! Web Hosting - Let the expert host your web site > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/