[TechAssist] Re: AutoVision VCP model VE6825 made by Daewoo

  • From: "J Silverman" <greentron@xxxxxxx>
  • To: <techassist@xxxxxxxxxxxxx>
  • Date: Fri, 7 Oct 2005 23:26:25 -0400

Money! You mean they give you money to fix that stuff? Here they expect me
to pay for the privilege, plus a little extra for the trouble of bringing it
in.
Jerry Silverman Greentron Inc
Mail to: greentron@xxxxxxx
4 Newland Ave Greenville SC
29609                864 232 3889
----- Original Message -----
From: "Paul" <dntwntv@xxxxxxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Friday, October 07, 2005 8:56 PM
Subject: [TechAssist] Re: AutoVision VCP model VE6825 made by Daewoo


> Yea,some people will do anything for money. :)
> I found broken wires that go through hinged door. My fault. All's well
now.
>                                                                       Paul
> J Silverman <greentron@xxxxxxx> wrote:
> Hardly anyone left crazy enough to fool with these things!
> Jerry Silverman Greentron Inc
> Mail to: greentron@xxxxxxx
> 4 Newland Ave Greenville SC
> 29609 864 232 3889
> ----- Original Message -----
> From: "Paul"
> To:
> Sent: Friday, October 07, 2005 5:28 PM
> Subject: [TechAssist] Re: AutoVision VCP model VE6825 made by Daewoo
>
>
> > Well Jerry
> >
> > I took it apart and checked all the end sensor and plug solder,
everything
> looked OK. I looked at the solder on the center led and there it was. A
ring
> crack. Had to use my heavy duty eyeball stretcher to see it. It was making
> just enough contact for a dim output that showed it was working on my
> infrared detector. After repairing and touching up the end sensors just
for
> drill, put it back together enough to check it, and it works. Played a
tape
> and ejects normally. The stop button doesn't work so have to see if I did
> something to cause that or if there is a setting that might over-ride the
> stop. Thanks for the info. You were the only one on the list that
> responded. Much appreciated.
> > Paul
> >
> >
> > J Silverman wrote: No, the K and G decks are not used
> in new products. I dont think I have any
> > information from Daewoo that is less than 5 years old. I see newer
Daewoo
> > mechanisms in RCA or Toshiba tvcrs assembled in Mexico. But people do
> bring
> > in off-brand new looking VCPs and VCRs used in vehicle applications that
> > have these older Daewoo mechanisms. Usually says "Made in China".
> > Apparently, some specialty suppliers for vehicle systems have these
things
> > made up for them and have identical replacement units priced at $300 to
> > $400. Wheather they still are able to import them or they just kept
> > inventory from some original purchase I dont know as the suppliers dont
> want
> > to give out any information. Sometimes we have been able to repair these
> > things and other times we had to adapt a different model to fit in its
> > place. Now we no longer see this type of vcp or vcr in the stores and
only
> > see them in some distributor catalogs at the $300 to $400 prices.
> > Jerry Silverman
> > Greentron Inc
> > 4 Newland Ave
> > Greenville SC 29609
> > Fax/Phone 864 232 3889
> > mail to: greentron@xxxxxxx
> > ----- Original Message -----
> > From: "Paul"
> > To:
> > Sent: Friday, October 07, 2005 2:38 PM
> > Subject: [TechAssist] Re: AutoVision VCP model VE6825 made by Daewoo
> >
> >
> > > Jerry
> > > It has," made by Daewoo" on the back of it. I had heard that Daewoo
was
> > not helpful if you were not an ASC. I don't work on Daewoo products at
> all,
> > but this is a special need so I am trying to help if I can. Are the K
and
> G
> > decks in the latest equipment that they make? This looks like it is
brand
> > new and never been used. Mode sw and and end sensors not out of the
realm
> of
> > possibility, but haven't had this problem with new sets. It is a D/C
only
> > unit so I thought if I could get the power supply schematic that would
> help
> > eliminate any problems there. The center led is working but have to just
> > about completely disassemble to get to the end sensors to check for bad
> > solder joints or missing 5v. Didn't want to get that far into it if I
cant
> > fix it.
> > >
> > >
> > Paul
> > >
> > >
> > > J Silverman wrote:
> > > Does it have the Daewoo brand name on it? We never had any luck
getting
> > > information from Daewoo on any model that did not have their brand
name
> on
> > > it. You might try the simple things first. check the sensor LED
system.
> Is
> > > the prism still there? Do you detect infra red coming out of the
prism?
> I
> > > have not had a problem with the Daewoo sensor LEDs or prisms or
> detectors
> > > but if they were dirty or weak you could have this symptom.
> > > Their different mechanisms have different means of detecting the
> cassette.
> > > The K-Mecha deck detects the cassette because the basket causes the
main
> > cam
> > > gear to turn and turns the mode switch, so on that model you might
clean
> > the
> > > mode switch and bend the contact springs a little. The basket blocks
the
> > > start sensor on the G-mecha deck to detect cassette in. On some of
their
> > > mechanisms there is a switch on the circuit board that detects
> > > cassette-down.
> > > Jerry Silverman
> > > Greentron Inc
> > > 4 Newland Ave
> > > Greenville SC 29609
> > > Fax/Phone 864 232 3889
> > > mail to: greentron@xxxxxxx
> > > ----- Original Message -----
> > > From: "Paul"
> > > To:
> > > Sent: Thursday, October 06, 2005 2:52 PM
> > > Subject: [TechAssist] AutoVision VCP model VE6825 made by Daewoo
> > >
> > >
> > > > Customer says this goes in a van that he bought and wants me to fix
if
> I
> > > can. He says a replacement is about $300.00. Hard to believe, but I
said
> I
> > > would look at it. It is made by Daewoo. I am going to have to find
some
> > > service info on it. It will not take the tape in. The drum spins when
> > > powered up. I loaded it by hand but it unloads, and will eject if
button
> > is
> > > pushed.
> > > > Will Daewoo sell me the manual if I am not an ASC? If so a phone
> number
> > > would be appreciated.
> > > > Paul
> > > >
> > > >
> > > > Paul ,B
> > > > Central TV&Video
> > > > 911W Grand Ave
> > > > Grover Beach Ca.
> > > > (805)481-8084
> > > >
> > >
> >
>
> --------------------------------------------------------------------------
> > > ---
> > > > This Email List is accessible to the general public through search
> > > engines. Remove: http://www.tech-assist.org/remove.htm
> > > > Set Vacation
> > > mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation
> > > > Lost Password: http://www.tech-assist.org and select "Login
> Problems?".
> > > > Email Archives: //www.freelists.org/archives/techassist/
> > >
> >
>
> --------------------------------------------------------------------------
> > ---
> > > This Email List is accessible to the general public through search
> > engines. Remove: http://www.tech-assist.org/remove.htm
> > > Set Vacation
> > mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation
> > > Lost Password: http://www.tech-assist.org and select "Login
Problems?".
> > > Email Archives: //www.freelists.org/archives/techassist/
> > >
> > >
> > >
> > > Paul ,B
> > > Central TV&Video
> > > 911W Grand Ave
> > > Grover Beach Ca.
> > > (805)481-8084
> > >
> >
>
> --------------------------------------------------------------------------
> > ---
> > > This Email List is accessible to the general public through search
> > engines. Remove: http://www.tech-assist.org/remove.htm
> > > Set Vacation
> > mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation
> > > Lost Password: http://www.tech-assist.org and select "Login
Problems?".
> > > Email Archives: //www.freelists.org/archives/techassist/
> >
>
> --------------------------------------------------------------------------
> ---
> > This Email List is accessible to the general public through search
> engines. Remove: http://www.tech-assist.org/remove.htm
> > Set Vacation
> mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation
> > Lost Password: http://www.tech-assist.org and select "Login Problems?".
> > Email Archives: //www.freelists.org/archives/techassist/
> >
> >
> >
> >
> > Paul ,B
> > Central TV&Video
> > 911W Grand Ave
> > Grover Beach Ca.
> > (805)481-8084
> >
>
> --------------------------------------------------------------------------
> ---
> > This Email List is accessible to the general public through search
> engines. Remove: http://www.tech-assist.org/remove.htm
> > Set Vacation
> mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation
> > Lost Password: http://www.tech-assist.org and select "Login Problems?".
> > Email Archives: //www.freelists.org/archives/techassist/
>
> --------------------------------------------------------------------------
---
> This Email List is accessible to the general public through search
engines. Remove: http://www.tech-assist.org/remove.htm
> Set Vacation
mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation
> Lost Password: http://www.tech-assist.org and select "Login Problems?".
> Email Archives: //www.freelists.org/archives/techassist/
>
>
> Paul ,B
> Central TV&Video
> 911W Grand Ave
> Grover Beach Ca.
> (805)481-8084
>
> --------------------------------------------------------------------------
---
> This Email List is accessible to the general public through search
engines. Remove: http://www.tech-assist.org/remove.htm
> Set Vacation
mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation
> Lost Password: http://www.tech-assist.org  and select "Login Problems?".
> Email Archives: //www.freelists.org/archives/techassist/

-----------------------------------------------------------------------------
This Email List is accessible to the general public through search engines. 
Remove: http://www.tech-assist.org/remove.htm
Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation
Lost Password: http://www.tech-assist.org  and select "Login Problems?".
Email Archives: //www.freelists.org/archives/techassist/

Other related posts: