[tcb] Re: tape scrub glue scrub strip scrape scrub strip scrape scrub rinse zinc coat rinse paint Whew!
- From: Gerald Livingston <gerald.tcb@xxxxxxxxxxxxx>
- To: tcb@xxxxxxxxxxxxx
- Date: Wed, 3 Mar 2010 23:05:02 -0600
End of month would be pushing it. My drag link should be here Friday so
I can tighten up the steering but I'm still trying to pinpoint a good
time for me to make the 200 mile round trip to get the 5x5 birch in
Houston. I'll check one or two slightly closer places tomorrow that I
missed on google when I searched before but I'm not hopeful.
My local lumber man hasn't gotten me my pieces for the Westy bench seat
yet either. Going to have to rapid-cure those in a bathroom with a
propane heater.
I'm shooting for the Classic.
G2
On Wed, 3 Mar 2010 19:27:03 -0800 (PST)
sammie smith <bugcollections@xxxxxxxxxxxxx> wrote:
> Looking good Gerald. Is it going to be roadworthy by March 27 for a
> drive to the Nac show. We are not that far from you.
>
> --- On Wed, 3/3/10, Gerald Livingston <gerald.tcb@xxxxxxxxxxxxx>
> wrote:
>
>
> From: Gerald Livingston <gerald.tcb@xxxxxxxxxxxxx>
> Subject: [tcb] tape scrub glue scrub strip scrape scrub strip scrape
> scrub rinse zinc coat rinse paint Whew! To: tcb@xxxxxxxxxxxxx
> Date: Wednesday, March 3, 2010, 7:47 PM
>
>
> tape scrub glue scrub strip scrape scrub strip scrape scrub rinse
> zinc coat rinse paint Whew!
>
> Shiny POR-15. That stuff goes a LONG way when you're not worried about
> 2-coating because it's going to be in a 0-traffic area (covered by
> plywood). Lots of rust but only minor pitting in most places. Some
> pinholes but no seriously thin metal. I'll J-B Weld the pinholes.
>
> I got black POR because most of it will be in covered places and I
> wanted the contrast to see where I'm painting it. I'll topcoat any
> visible places later.
>
> Last seal on the pop-top. Have to figure out how to clean up the
> excess glue sprayed by my overzealous helper.
>
> http://www.texasvolksbus.org/1970/2010-02-22_2010-03-03/index.html
>
> G2
>
Other related posts:
