Make sure the disk is on the rotor shaft correctly. You may need to rotate the disk a little so it will go down on the shaft. Larry P. On Sun, 14 Nov 2004 17:43:24 -0800 (PST) Lee Le <heyleele@xxxxxxxxx> writes: > I just tried to install the following kit//EMPI accufire conversion > kit//. I take the points out. Put the module in and bolt it. Put the > accufire rotor wheel in and install the stock rotor backon top of > it. For some reason the rotor wheel makes the rotor sit up a little > too high..I cant get the distributor cap on without trying to force > it down. > I checked the wire guide that goes thru the distrubutor...installed > correctly. There is also no unnecessary gaps. Didn't use the spacer > proveded cause it's a mech advance dist. Possibilities? AM I > supposed to force the dist cap down? I took the accurfire rotor > wheel out and put just the old rotor back on..goes down perfectly. > Then put the accu fire wheel..back on..sitting flush with the dist > shaft...and rotor back on..still..wont let me put the cap on? Please > help! ?? Condensor was taken out too. > > 71 westy type 2 1600cc bosch dist. > > > --------------------------------- > Do you Yahoo!? > Check out the new Yahoo! Front Page. www.yahoo.com > > > >