I just tried to install the following kit//EMPI accufire conversion kit//. I take the points out. Put the module in and bolt it. Put the accufire rotor wheel in and install the stock rotor backon top of it. For some reason the rotor wheel makes the rotor sit up a little too high..I cant get the distributor cap on without trying to force it down. I checked the wire guide that goes thru the distrubutor...installed correctly. There is also no unnecessary gaps. Didn't use the spacer proveded cause it's a mech advance dist. Possibilities? AM I supposed to force the dist cap down? I took the accurfire rotor wheel out and put just the old rotor back on..goes down perfectly. Then put the accu fire wheel..back on..sitting flush with the dist shaft...and rotor back on..still..wont let me put the cap on? Please help! ?? Condensor was taken out too. 71 westy type 2 1600cc bosch dist. --------------------------------- Do you Yahoo!? Check out the new Yahoo! Front Page. www.yahoo.com