Dani,
I'll take a look at my studio DAW and see if I can pull it off.
What's your email, so I can send as an attachment.
Dave Carlson
Oregonian, woodworker, Engineer, Musician, and Pioneer
----- Original Message -----
From: "Dani Pagador" <axs.brl@xxxxxxxxx>
To: <sib-access@xxxxxxxxxxxxx>
Sent: Thursday, September 17, 2015 04:33 PM
Subject: [sib-access] Re: Customising the Sib Access Dictionary--sharps and
flats
You wouldn't happen to have a copy of that inelegant, but very
necessary dictionary??? Or instructions on how to put it together?
On 9/17/15, Dave Carlson <dmarc-noreply@xxxxxxxxxxxxx> wrote:
Dani,If you wish to unsubscribe, send a blank message
Have you tried using the asterisk (*) as a wildcard? I think you can put
in
D* and Repronounce it as Delta. Have not played with this in years, but
give
it a try.
I actually created a huge dictionary with the phonetic and all the octave
combinations, as well as with flats and sharps. I created it in Notepad
and
then pasted it into the text form of the JAWS dictionary file for
Sibelius.
But that was the un-elegant, hard way to do it. A wildcard might have been
the cleaner solution.
Dave Carlson
Oregonian, woodworker, Engineer, Musician, and Pioneer
----- Original Message -----
From: "Dani Pagador" <axs.brl@xxxxxxxxx>
To: "sib-access" <sib-access@xxxxxxxxxxxxx>
Sent: Thursday, September 17, 2015 10:31 AM
Subject: [sib-access] Customising the Sib Access Dictionary--sharps and
flats
Hi, Everyone.
I have managed to customize my Sib .jdf file so that instead of using
A-G to announce pitches, JFW uses the phoenetic equivalent. I have
only managed to do it, though, where there is just a pitch and an
octave e.g., D4=Delta4.
There's supposed to be something in the Verbosity settings where you
can check this and it does it, but my quirky computer/jfw/computer
gods have all conspired against me and won't let it happen according
to the Access Guide.
Now I need to ask ... and will hope Dan is still on list ... how to
get it so I can have this happen with accidentals as well. I tried
using the # for sharp, but still get "F sharp 3".
Ideas?
Thanks,
Dani
If you wish to unsubscribe, send a blank message
with the single word, unsubscribe - in the Subject line to:
sib-access-request@xxxxxxxxxxxxx
If you wish to unsubscribe, send a blank message
with the single word, unsubscribe - in the Subject line to:
sib-access-request@xxxxxxxxxxxxx
