[SI-LIST] Routing 10G differential lines over Standard FR-4
- From: <sunil.mekad@xxxxxxxxx>
- To: <si-list@xxxxxxxxxxxxx>
- Date: Mon, 16 May 2005 17:03:54 +0530
Hi Everyone,
I was planning to route high speed differential traces 10Gbps over
standard FR-4 material. Can anyone suggest which FR-4 material can be
used (Nelco N4000-6 or Rogers RO4350)? Is it possible to do use standard
FR-4 without compromising signal quality.
Also is it recommended to route these traces over microstrip rather than
striplines traces? If I route it over stripline then it would require
vias to be put on every pair of these differential traces .. I am not
too comfortable doing that!!
Can anyone tell what can be done? Thanks in anticipation,
Regards,
Sunil
Confidentiality Notice=0D
The information contained in this electronic message and any attachments to=
this message are intended
for the exclusive use of the addressee(s) and may contain confidential or=
privileged information. If
you are not the intended recipient, please notify the sender at Wipro or=
Mailadmin@xxxxxxxxx immediately
and destroy all copies of this message and any attachments.
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List FAQ wiki page is located at:
http://si-list.org/wiki/wiki.pl?Si-List_FAQ
List technical documents are available at:
http://www.si-list.org
List archives are viewable at:
//www.freelists.org/archives/si-list
or at our remote archives:
http://groups.yahoo.com/group/si-list/messages
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu
Other related posts:
