[SI-LIST] Battery Monitoring PCB design tradeoff...

Hello to all!
I'm doing a battery monitoring card with the MAX1660.
The card basicaly has a high current loop (this loop has the pack external 
connector, the battery connector and a 30mOhm resistor to measure
the current). My doubt is:
where should I put the analog sampling part of the MAX1660?
Solution 1
 +Near the sense resistor
    Pro:
     -> minimize the trace length from the sense resistor to the analog input
    Con:
     -> more vulnerable to noise
Solution 2
  +Far from the sense resistor
   Pro:
    -> avoid the noise generated by the high current loop 
   Con:
     -> the trace length from the sense resistor to the analog input is bigger
Maxim in the MAX1660 Eval kit puts the Max1660 far from the high current loop 
(the trace from the sense resistor is bigger).

Is this the best solution? 

Thanks in advance
Best Regards
Bruno
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field

or to administer your membership from a web page, go to:
http://www.freelists.org/webpage/si-list

For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field

List FAQ wiki page is located at:
                http://si-list.org/wiki/wiki.pl?Si-List_FAQ

List technical documents are available at:
                http://www.si-list.org

List archives are viewable at:     
                http://www.freelists.org/archives/si-list
or at our remote archives:
                http://groups.yahoo.com/group/si-list/messages
Old (prior to June 6, 2001) list archives are viewable at:
                http://www.qsl.net/wb6tpu

Other related posts: