Do you guys know any one in NJ? Somebody had -ve opinion on Essex camera in RUG this month. On 9/25/05, Richard Knoppow <dickburk@xxxxxxxxxxxxx> wrote: > > > ----- Original Message ----- > From: "Jerry Lehrer" <jerryleh@xxxxxxxxxxx> > To: <rollei_list@xxxxxxxxxxxxx> > Sent: Saturday, September 24, 2005 8:30 PM > Subject: [rollei_list] Re: Advice needed > > > > Richard, > > > > Do you really think that Harry now gets $300 for a CLA > > on the simplest post war Rolleiflex made? > > > > Jerry > > > I don't know what Harry's current charges are but this > camera may need more than a routine CLA. My 2.8E cost about > $300 to get into shape because it was a beater and had lots > of problems. I don't know how much more complicated later > Rolleis are than the MX-EVS, the film wind is about the > same. The F series cameras have a more complex method of > guiding the front end. It has screw jacks to adjust it for > parallelism rather than relying on shims. > Of course, the answer would be for the original poster to > contact Harry. I am sure Harry does work equal to anyone > else (if not better) and can personally vouch for him. > > > OCEANSIDE CAMERA REPAIR > 909 AVIATION BLVD. #4 > MANHATTAN BEACH, CA 90266 > rolleirepairsbyharry.com <http://rolleirepairsbyharry.com> > 310-374-6506 > http://www.rolleirepairs.com > > > --- > Richard Knoppow > Los Angeles, CA, USA > dickburk@xxxxxxxxxxxxx > > --- > Rollei List > > - Post to rollei_list@xxxxxxxxxxxxx > > - Subscribe at rollei_list-request@xxxxxxxxxxxxx with 'subscribe' > in the subject field OR by logging into > www.freelists.org<//www.freelists.org> > > - Unsubscribe at rollei_list-request@xxxxxxxxxxxxx with > 'unsubscribe' in the subject field OR by logging into > www.freelists.org<//www.freelists.org> > > - Online, searchable archives are available at > //www.freelists.org/archives/rollei_list > >