Thanks, I've seen the BMI fin Jig and see the HPR-1 advertised , but the HPR-1 seems to be not available. Does anyone know of a source for the HPR-1 fin jig? Mike Michael Lesnick Axiom Healthcare Group 18135 Santa Lauretta Cir Fountain Valley, CA 92708 714-594-5720 - Office Phone 714-323-5968 - Cell 714-968-7076 - Fax MikeL@xxxxxxxxxxx -----Original Message----- From: roc-chat-bounce@xxxxxxxxxxxxx [mailto:roc-chat-bounce@xxxxxxxxxxxxx] On Behalf Of Lakestake Rocketry Sent: Tuesday, December 20, 2011 8:53 PM To: roc-chat@xxxxxxxxxxxxx Subject: [roc-chat] Re: Fin Jig for Large Daimeter Airframes - 5.5 inch diameter or larger Good evening Mike, You can buy jigs, but you usually just make them. They really should be required for any L3 cert. Use them to augment common sense. Matt On Tue, Dec 20, 2011 at 4:13 PM, Lesnick, Mike <mikel@xxxxxxxxxxx> wrote: > Does anyone have thought and advice on use of fin jigs (to hold fins > straight while under construction) for larger airframes (over 5inches in > diameter)? > > > > · Can you buy them if so what sources? > > > > · Other options? > > > > · Necessary & How Valuable? > > > > Thanks > > > > Mike > > > > Michael Lesnick > > Axiom Healthcare Group > > 18135 Santa Lauretta Cir > > Fountain Valley, CA 92708 > > 714-594-5720 - Office Phone > > 714-323-5968 - Cell > > 714-968-7076 - Fax > > MikeL@xxxxxxxxxxx > > > > > > -- ROC-Chat mailing list roc-chat@xxxxxxxxxxxxx //www.freelists.org/list/roc-chat -- ROC-Chat mailing list roc-chat@xxxxxxxxxxxxx //www.freelists.org/list/roc-chat