A problem with food trays is that they don't have any ridges on the bottom. Prints tend to stick and there is no way of getting tongs under them. Jerry -----Original Message----- From: pure-silver-bounce@xxxxxxxxxxxxx [mailto:pure-silver-bounce@xxxxxxxxxxxxx] On Behalf Of Allen Zalsman Sent: Tuesday, February 22, 2005 7:22 PM To: pure-silver@xxxxxxxxxxxxx Subject: [pure-silver] Stainless Steel Trays HI I have a question about stainless steel trays. There is a restaurant=20 going out of business, and they have a lot of trays and deep pans. Are these good for doing black and=20 white developing of film and paper? allenz01@xxxxxxx =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D= =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D= =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D= =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there. ============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.